Pulptester COXO C-Pulse COX000621

Description Pulptester C-Pulse Coxo

The C-Pulse pulp tester is a device for testing the vitality of the pulp using electrical stimulation.

During the hour of the procedure, the strum stimulates the nerve in the middle of the tooth, as a result the patient feels a sharp pain.

As a result of further investigations, it became possible to detect the response of the pulp to stimulation beyond the threshold of sensitivity, which allows the establishment of the state of the pulp nerve.

In this way, the device will ensure highly efficient pulp life.

features:

Swiss modes (high, middle, low)

A weak and pulsating stimulus will be sustained in the selected speed mode (low-medium-high)

Hand-held design for patient comfort, easy to use

If the patient feels pain, simply press the button. Giving an incentive to immediately jump, and then the numbers will appear on the screen for another 3 minutes.

In the digital range, the peak of the electrical stimulus reaches 80. In the range of 0 to 40, the patient feels pain, which means that the dental nerve is alive.

Such a reaction is observed in the range of 40 to 80, which means that partial necrosis of the dental nerve has occurred.

Although there is no reaction as described above, the dental nerve is outsized.

The device automatically switches off three times after the procedure is completed (battery saving).

Technical characteristics and equipment class:

Output voltage: 9.0

Output flow: 90 mA (miliamps)

Equipment class: Class II (Medical equipment classifier)

Protection from the penetration of radians: daily

Size: 186x38x24 mm

Clean vaga: 220g

Installation is not suitable for vikorstanya with busy pain-killing sumishes, which include nitrous oxide or ether.

Zastosuvannya:

Insert the cable into the connector of the main unit, then connect the stainless steel hook and test electrode to the machine interface.

Thoroughly clean the tooth that causes tooth decay; Dry the surface of the tooth to prevent the passage of the electrical stimulus through the teeth, which can lead to the appearance of a soft electrical stimulus. Also, pay special attention to the dryness of the tissues in order to advance the passage of the struma to the exposed tooth, otherwise an inaccurate signal (electrical stimulation) will be given.

Attach the stainless steel latch to one of the rollers, then select the desired speed setting (high, medium or low speed).

Apply a drop of conductive glue or toothpaste to the contact surface (1/3 across) between the test electrode and the selected tooth. Then press the soft button. Then place the test electrode on the surface of the tooth being diagnosed. After which the device is activated and numbers immediately appear on the screen.

If the patient experiences mild toothache or anesthetic infusion, remove the test electrode from the tooth and record the digital data shown on the screen. These indicators are a numerical expression of the tooth’s reaction to electrical stimulation.

We calculate the peak of the reaction to electrical stimulation as the number 80. In the range of 0 to 40, the patient experiences either anesthesia or anesthesia to determine the vitality of the nerve. If in the numerical range from 40 to 80, the patient is aware of the above-described reaction, which indicates the partial death of the dental nerve. If the numerical value reaches 80, other than the above-described reaction, one should not be afraid, but one should note that the dental nerve is not alive.

After the procedure is completed, the dimming results are displayed on the rare crystal display for 3 lines, and then the device dims automatically.

* If the LO symbol appears on the display when the device is turned down, you need to charge the battery.

Equipment:

Stainless steel hook 4 pcs

Instructions for use 1 piece;

Cable 1pc;

Test electrode 2 pcs;

Pulptester 1 piece