GRADIA Direct Lo Flo BW 1 syringe

A multi-purpose light-cured, radiopaque, fluoride-releasing, microfilic hybrid composite. Thanks to the new special GC technology - HDR (Prepolymerized High Density Filler) - it resists abrasion well. Moreover, the higher viscosity (lower fluidity) is ideal for class III and V cavities, as well as for restorations of carious cavities on the root surface.
For use only by professional dentists and only in accordance with the recommended indications.

INDICATION.
• Restoration of strips of I, II, III, IV, V classes (especially small strips of I class, shallow strips of V class and other small strips).
• Restoration of carious lesions on the root.
• Restoration of milk teeth.
• Cavity sealing during tunnel preparation.
• Surface sealing in case of hypersensitivity.
• Use as a base, lining, filling in the cavity.
• Use as a sealant.
• When splinting loose teeth.
• Addition of existing composite restorations.

CONTRAINDICATION.
Direct overlap of the pulp.
In some cases, the material may cause hypersensitivity in some people. If such reactions are observed, stop using the material and consult a doctor.
APPLICATION INSTRUCTIONS.
1. Preparation.
1) Hold the syringe with the nose up, remove the protective cap by turning it counterclockwise. Make sure that the light of the polymerizer or natural light did not fall on the material.
2) Carefully screw the nozzle (plastic or metal) clockwise.
When working with children, it is recommended to use a plastic nozzle.
3) After installing the nozzle, put the protective cap on it and do not remove it until you start using it.
2. Preparation of the cavity.
Prepare the cavity in the usual way.
Use a material based on calcium hydroxide to cover the pulp.
3. Choice of color.
Choose from 7 colors: A1, A2, A3, A3.5, AO3, CV and BW.
*Vita is a registered trademark of Vita Zahnfabrik, Bad Sackingen, Germany.
4. application of a light-curing adhesive system.
To bond Gradia Direct LoFlo to tooth tissues, use a light-curing adhesive system. Use of UniFil Bond or GABond is recommended.
Note: Follow the manufacturer's instructions when using a light-curing adhesive system.
5. Applying Gradia Direct LoFlo.
Remove the protective cap from the syringe nozzle. To remove air from the nozzle, hold the syringe in an upward direction, gently pressing on the plunger of the syringe until the material reaches the outlet of the nozzle.
If there is air inside the nozzle, bubbles may form during squeezing.
air.
Place the nozzle as close as possible to the cavity and, slowly pressing the plunger, squeeze the material into it. You can also squeeze the material onto the kneading paper, and then insert it into the cavity with a suitable tool.
When screwing on the nozzle, make sure that there is no material left at the junction of the nozzle and the syringe. If the material does not come out evenly, remove the tip and squeeze the material directly from the syringe to make sure it comes out at all. The material begins to harden under the influence of the light of the polymerizer or daylight. When using kneading paper, keep the material away from light. After finishing work, immediately remove the nozzle and screw on the protective cap.