Ionosit (Ionosit, DMG), syringe 0.33 g

Recommended use:
1. Before preparing the tooth, clean it, remove all residues after cleaning with a stream of water. It is not necessary to apply rubber dams if there is another possibility to control humidity. Contamination with saliva should be avoided during application.
2. Prepare the cavity using the usual adhesive method. Grind the edges of the enamel. Protect the pulp in deep cavities.
3. pickling agents are preferred, for example, Total Etch. Follow the instructions for the application of the material used.
4. Apply an adhesion enhancer (for example, Contax) following the application instructions.
lonosit-Baseliner can also be applied without an adhesion enhancer. In this case, the adhesion can be compared with ordinary cement (glass ionomer cement, phosphate cement).
5. lonosit-Baseliner can be used both as an ordinary gasket (covering the base of the cavity) and to cover the entire cavity (for stress relief). Apply lonosit-Baseliner with a brush or any spherical tool in a layer about 1 mm thick
6. curing with a suitable dental lighting device for at least 20 seconds.
7. Apply the composite filling material according to the manufacturer's instructions. It is recommended to use EcuSphere.