Ftorax Plastic without veins 300+150g

Ftorax - hot-curing plastic for the bases of prostheses, modified by Fluorine rubber. Stoma manufacturer.

Indications for the use of Ftorax plastic for orthopedic dentistry:

plastic of hot polymerization for the manufacture of full / partial dentures

- complete prostheses of the upper and lower jaw;

- partial prostheses;

Advantages of Ftorax plastic:

- accurate form transfer;

- high bending strength limit;

- optimal elasticity;

- high cosmetic quality of prostheses due to translucency and the introduction of "veins" into the composition of the material, imitating the soft tissues of the oral cavity;

- good polishability;

Instructions for use of Ftorax:

powder and liquid are mixed in a ratio of 2: 1;
the phase of plastic modeling is about 20 min.;
polymerize in a water bath in dental cuvettes, raising the temperature to boiling gradually over 40-50 min.;
polymerization lasts about 30 min.;
only a completely cooled prosthesis is pulled out of the cuvette;