JEN-DUACEM (JEN-DUACEM) CHM 4 syringes of 2 g each

JEN-DUACEM, composite cement 4x2g Jendental

Purpose of JEN-DUACEM:

• Cementation of tabs and overlays
• A chain of fiber systems, metal, fiberglass and carbon fiber posts and veneers
• Fixation of indirect restorations
• The basis for the construction of religious cults from composite material
• A chain of molded Kultei tabs
• Fixation of adhesive bridge prostheses

Advantages of Jen-Duacem :

• Insoluble in oral fluids
• Contains fluorides
• X-ray contrast
• Thixotropic with special fluidity characteristics
• Very small film thickness (form 8 microns) and high filling content
• Basic physical characteristics
• Excellent adhesion to dental tissues, metal and ceramics

Some tips for using Jen - Duacem :
When carrying out bonding procedures, it is necessary

Give careful control of oral fluids to prevent contamination of both cement and recycled cement. A good result can be achieved with a rubber dam, gingival retraction with rollers and threads in combination with an evacuation evacuation evacuation evacuation evacuation evacuation system.

Place equal amounts of pastes A and B on the kneading pad. Mix the two pastes for about 20 seconds until you get a smooth mixture.

If the clinical case requires only chemical rejection, the working time we have at 23ºC is 120 seconds. Complete curing of the material occurs after 6-8 minutes. In the case of unfolding, the cement reaches strength after 20-30 seconds of radiation.

Apply a thin layer of the mixed paste onto the restoration on one side and on the surface of the cavity, then place the restoration in the cavity. Avoid applying excess to the restoration, as well as to the walls of the cavities.

Remove excess material with a suitable tool. Avoid excessive removal of material, especially at the restoration-fullness interface. A small excess of material can be left if necessary.

Please deposit materials with a curing light where available. When using all-ceramic or composite restorations, reverse the Jen-Duacem by directing the lamps through the restoration.

The restoration of this method requires more time, an adequate thickness of the restoration.

To prevent the formation of a layer integrated with oxygen, use a barrier gel. The gel is applied in the area of fissures after removal of excess material, however, before polymerization of the material.

Complete set: Set of 4 syringes of 2 g, (2 syringes of paste A and 2 syringes of paste in one shade)

Shade: CHM (Chameleon)

System: paste/paste