Express XT Light Body 2x50 ml

Express XT Light Body - vinyl polysiloxane corrective impression mass.

Appointment:

• Short bridge structures (up to 3 units)
• Extended bridge structures (4 units or more)
• Inlay / onlay / overlay tab
• Pin cult tabs

Advantages:

• Optimal balance of clinically important properties
• Thixotropy
• Increased hydrophilicity and excellent fluidity
• Elasticity in combination with very high tensile strength - for extracting the impression without tearing and stretching the material
• Almost 100% shape recovery after stretching, which practically eliminates the risk of distortion of the print
• High spatial stability
• Due to the lack of shrinkage, the model can be cast repeatedly at any time within 2 weeks
• It is conveniently and easily mixed and dosed using the Garant ™ dispenser gun

One-step technique:

• Fill the impression spoon with pre-applied spoon adhesive (drying time 5-15 min), keeping the mixing tip of the device immersed in the mass
• Apply the correction material from the Garant ™ gun to the prepared area, slowly insert the impression spoon into the oral cavity and hold it without applying pressure
• Remove the impression from the oral cavity after the curing time (3 min)
• Remove excess material from the oral cavity, place the impression in a disinfectant solution for 10 minutes, then rinse the impression with water for 15 seconds

Two-stage technique:

Fill the impression spoon with pre-applied spoon adhesive (drying time 5-15 min), keeping the mixing tip of the device immersed in the mass
Slowly insert the impression spoon into the oral cavity and hold it without applying pressure
Remove the impression from the oral cavity after 3 minutes, clean and dry it
Cut out podnutreniya, interdental partitions, etc. , If necessary, make diversion channels
Apply the corrective impression material from the Garant ™ gun to the obtained base impression on the appropriate side and / or on the prepared area and insert the impression spoon into the oral cavity
Remove the impression from the oral cavity after the corrective material has hardened
Remove excess material from the oral cavity, place the impression in a disinfectant solution for 10 minutes, then rinse the impression with water for 15 seconds.

Delivery set:

• Express™ XT Light Body
• 2 cartridges of 50 ml,
• 10 yellow Garant mixing nozzles