Bonasil (BONASIL), C-silicone impression mass, SET

Bonasil impression material based on C-silicone is widely used in modern dentistry and orthodontics for the production of high-quality casts.

The products of the Greek company DMP have repeatedly proven their effectiveness and reliability as a result of use in clinical conditions and private practice.

Appointment and use of Bonasil

• production of the main layer using double impression technologies;
• forming casts using "sandwich" technologies, in particular for the subsequent production of ceramic veneers;
• formation of functional casts for further production of models for partial or full prosthetics;
• individual registration of occlusion.

The high fluidity of the Bonasil material allows you to perform the following precise actions, obtaining the creation of a closing valve with a lower level of fixation.

Main characteristics of Bonasil

• The polysiloxane base of Bonasil allows you to easily replace the mass and quickly achieve a homogeneous substance of the material necessary for working with it.
• Bonasil does not stick to the latex base of the gloves in which the dentist works, and the polymerization of the masses occurs without deposition.
• The manufacturing company will be able to obtain a unique polymer formula of the material without increasing the amount of the conical product.
• The chemical properties of Bonasil allow you to improve the plaster formula even a week after the impression is made.

Features of working with Bonasil
The connection of the main mass and the activator takes place within 45 seconds.

Processing the material from the start of work takes approximately 1 minute.

To load the mass, you need to hold the next spoon in the cavity for at least 4 minutes, and then completely set it aside for further processing.

A blind mass is inherent in a high ligament.

After the form recovers to 98%.

A linear change in size is allowed by 0.3%.

By changing the number of activators when replacing the mass, you can increase or decrease the delay time of the slip.

Temperature also affects the continuation of the process. At a temperature standard of +23 degrees, solidification of the mass can be rejected, the temperature can be lowered and shortened - increased.

Application method
Measure the required amount of material with a measuring spoon and put it on the palm of your hand. At the same time, the excess must be removed. On the mass meter, make a sender and give it activating things in quantities equal to the diameter of the meter. After use, immediately close the container with the materials everywhere.

The components are thoroughly mixed with the fingertips, without showing a homogeneous mass. The material is publicized in the impression spoon, after which it is quickly served to the necessary participation and held in the given position until the masses are fully confirmed.

When working with Bonasil Light, the ingredients are mixed with a spatula on a special block, after which the above steps are repeated.

Complete set Bonasil
It is rational to purchase a set of Bonasil, which includes:

• the main mass in the volume of 900 ml;
• correction mass 140 ml;
• universal activator 60 ml.

The basis of the impression material is polysiloxane. This organosilicon polymer is actively used in various fields, and its main advantages are considered complete safety for humans, absence of toxins and allergens.