Ceramfil Molar A2 (Ceramfil Molar) 25 g + 15 ml

description: Two-component (powder and liquid) material for adhesive restorations. It is used both independently and in combination with composites to reduce stress during restorations of lateral teeth. After hardening, it has high strength characteristics. Characteristics: • very high hardness and strength • good consistency and easy modeling • chemical adhesion to tooth tissues • quickly reaches a neutral pH level • releases fluoride • biocompatible with tooth tissues • conforms to ISO 9917, 1991: Restorative. Package content: 25g. powder / 15 ml. liquid / measuring spoon / accessories

purpose: • restoration of small chewing cavities of the back teeth • production of a stump for a crown • filling of cavities of milk teeth of all classes • sandwich technique for composites • restoration of teeth in the elderly Mixing ratio: 4: 3 (4 measuring spoons of powder to 3 drops of liquid ). The recommended minimum amount for good mixing is 4 measuring spoons of powder and 3 drops of liquid (0.4 g of powder and 0.12 g of liquid). Mixing and installation time: • mixing hour - 30 seconds • working time - 3 minutes • installation time - 6 minutes • working temperature + 23 ° C at a relative humidity of 50% Increased temperature or reduced humidity can change the working and installation time. Instructions for use: • Before use, shake the powder bottle several times. • Take the required amount of powder with a measuring spoon and place it on the mixing sheet. • Add the required amount of liquid. • To remove the lubricated ball and improve adhesion to the tooth tissue, it is recommended to use Conditioner Bond before applying the glass ionomer into the tooth cavity.

• Using a metal or plastic spatula, mix a portion of the powder with the liquid until a homogeneous mass is reached. The material should have a glossy surface and be used immediately. • If the cavity is deep, protect the pulp with a calcium hydroxide material. • Fill the tooth cavity with cement. The material is condensed with a plugger. Model the restoration. • Remove excess material and if you do not plan to cover the cement with a composite, apply a protective varnish