DENTO-PREP Microblaster sandblaster

DENTO-PREP™ is used with aluminum oxide powder and is designed to create micro-retention on ceramic, composite and metal surfaces prior to fixation and to enhance bonding.

The device operates on compressed air with a pressure of 2 to 5 kg/cm2 (30-120 psi). It is important that the air is dry and oil-free. Please make sure that there is a filter installed in the air duct and that water condensation does not enter the device.

DENTO-PREP™ is intended for use in dental offices and laboratories.

Quick release connector

There are a number of connector types for DENTO-PREP™, allowing it to be used with different outlets: KaVo, W&H, Sirona, BienAir and NSK. Remove the turbine handpiece, place the adapter on the turbine connector and connect the hose to the DENTO-PREP™.

If your turbine tip is a different type than the one above, the Midwest adapter is suitable for connecting to a standard 4-hole turbine outlet. The Midwest Connector is versatile and can be used with most turbine outlets

Using the Installation Kit DENTO-PREP will be connected directly to the air duct using a hose with a quick-release connector, which is included in the package. Recommended abrasives. Aluminum oxide particle size 20-80 microns.

WARNING!

Moisture and foreign particles can cause clogging!

External oral use:

• To create micro-retention cleansing and activation:

• crowns

• tabs/overlays

• pins

• Maryland bridges

• orthodontic brackets and braces

• To remove cement during recementing

• To check the fit of the casting by matting the cast metal

Intraoral use:

To create micro-retention before fixation, repair, correction of composite and ceramic restorations

For the creation of micro-retention/cleaning of the surface of teeth and cavities before composite restorations

Precautions

Always wear safety glasses. Never point the sprayer at the face or eyes, only at the surface to be treated. Treat surfaces from a distance of 2-10 mm. Avoid breathing air with abrasive materials. Always wear a mask. When using DENTO-PREP™ in the oral cavity, it is recommended to use a rubber dam to protect the teeth and soft tissues. Place the saliva aspirator as close as possible to the treated area.

Instruction

• Unscrew the powder container, fill it with aluminum oxide powder and twist it.

• Before using DENTO-PREP™ for the first time, it is recommended to experiment on different materials from porcelain, composite, metal.

• Point the nozzle of the device in the desired direction and keep it at a distance of 2-10 mm from the treated area.

• Press the power button and hold until the surface is evenly roughened. It only takes a few seconds.

• First release the button and only then remove it from the surface being processed

• After use, remove the powder from the container. Clean the system as described in the Cleaning section below.

• Disconnect the air duct.

• Clean the surface of the device. Do not immerse DENTO-PREP™ in water or other liquids to avoid clogging.

• Autoclave up to 135°C/275°F.

Cleaning

Plugs in the thin tubes inside DENTO-PREP™ can be removed by backflowing air.

For this it follows:

• Unscrew the powder container, close the nozzle with your finger and press the on button. This will clean the device using compressed air movement in the reverse direction. Sterilization DENTO-PREP™ can be autoclaved at a maximum temperature of 135°C /275°F. Remove the powder container before sterilizing. Make sure the entire system is completely dry before use after sterilization.

Delivery set:

a tip with a spray nozzle and a container for powder
duct (length 3 m) with a quick-release connector
Midwest adapter